compression stress的例句大全

When isocyanate index and density increase, compression stress is strengthened , and the compression set is improved.

增加异氰酸酯指数和密度,微孔弹性体的压缩负荷显著提高, 压缩变定性能改善.

In addition, three familiar sets of softened compression stress-strain relationship of concrete are showed.

此外, 也给出了常见的三种软化压应力 - 应变关系方程.

It is important formresidual compression stress in lay hardened of the wheel.

滚压力是保证强化效果的最主要参数.

According to the P axis superiority distribution position, the compression stress direction is extrapolated.

根据P轴的优势分布方位, 推侧其主压应力方向.

If the stress is above yield point, the column will be destroyed due to compression stress.

时成立.应力在屈服点以上时,由于压缩应力, 柱子将会破坏.

Three compression stress state is the main stress state for three-roll planetary rolling process, which m.

得出在三辊行星轧制过程中起到主要作用的是三向压应力状态, 有利于坯料的大变形和提高轧制管材性能.

Based on the researches of the other scholars and the critical state soil mechanics, theoretical formulas of the undrained strength under K0 compression and extension stress condition were derived with consideration of induced anisotropy.

从临界状态土力学出发，考虑K0固结引起的诱发各向异性，推导了K0固结条件下三轴压缩和三轴拉伸不排水强度的理论计算公式。

Stress distribution on the surface of alveolar bone is very complex, not simple compression or tension.

齿槽骨表面的应力分布非常复杂,同一部位三个主应力值相差很大,且多为反号, 不是简单的受拉或受压.

The relation of displacement ductility factor μ?, axial load ratio n, shear-compression ratio v and average bond stress of the reinforcements are quantified on the basis of early research.

并在以往研究的基础上拟合出矩形截面柱中间层中节点梁筋贯穿段平均粘结应力与组合体位移延性系数μΔ、轴压比n和剪压比v的定量关系；

Second, according to the parameters based on the common tri-axial compression and lateral confinement compression test on the undisturbed soil sample, this paper calculate the soil stress between piles and dry density on the use of FORTRAN program, thus make some important conclusions.

其次，采用原状土样进行室内常规三轴试验及侧限压缩试验，确定试验参数，代入前述理论公式，借助FORTRAN语言计算桩间土土体应力及其干密度，得出了一些结论；

Opening point, opening angle and maximal tangential stress on ellipse edge are presented under uniaxial compression, biaxial compression and uniaxial compression with fissure water pressure respectively.

分别给出了单向压力、双向压力、单向压力与裂隙水压力共同作用3种情况下椭圆边缘开裂点的位置、开裂方向和最大切向拉应力值。

The flow stress obtained in micro compression test was modified to eliminate the influence of friction.

结合微压缩实验讨论了流动应力的修正,即消除摩擦力对微压缩的影响.

It is shown in the static and dynamic compression stress-strain results, the curve has a typical three stages form. There are elastic stage, plastic stage, and close-grained stage after crushing.

从其静-动态压缩应力-应变曲线中可以看出，曲线是典型的三阶段形式，即弹性阶段，塑性阶段，及压溃后的密实阶段。

( b) For concrete in compression zone a stress-strain relation for repeated axial compressive cyclic loading, is adopted instead of that for reversed loading.

对混凝土受压区采用轴向重复加载的应力-应变关系而不是反复加载的。

Moreover, the invariants of the stress deviator were employed to analyze the metal deformation process of ring compression and hydro-bulging toroidal shell by numerical simulation, and also the simulated and experimented results have a good agreement.

并且通过数值模拟的方法，采用偏应力张量不变量对圆环压缩和环壳液压胀形过程中金属的变形进行了分析，模拟结果和实验现象一致。

The thrust nappe as a whole underwent Yanshanian and Himalayan compression and nappe-thrusting. In the Yanshanian period the principal compressional stress σ 1 was oriented in a 44 ° direction and the nappes was thrust northeastward with a total displacement of 26.6 km.

整个推覆构造带主要遭受了燕山期和喜马拉雅期挤压逆冲推覆作用，燕山期主压应力σ1方向为44°，由南西往北东推覆，总位移量26.6km；

Properties of stress relaxation and compression set of vulcanite during isothermal thermo-oxidative aging

硫化胶等温热氧老化时应力松弛和压缩永久变形性能的研究

Instantly the blood crept warmly over her body. Her nervous tension relaxed. Properties of stress relaxation and compression set of vulcanite during isothermal thermo-oxidative aging

热血立刻悄悄地流遍全身，使她的紧张心情松弛下来。硫化胶等温热氧老化时应力松弛和压缩永久变形性能的研究

It was found that tension residual stress is key factor for crack growth under cyclic compression.

结果表明,裂尖区域在循环压缩载荷作用下的残余拉伸应力是导致裂纹扩展的重要因素.

While at the same DS level, the releasing rate increased with the increase of drug loading, decreased with the increase of compression stress.

同一取代度的HC对布洛芬的释放量随着载药量的增加而增加，随着成片压力的增加而下降。